Free Engineering Tools · 10 calculators

Fire Dynamics and Detection Calculators

The hand calculations of fire dynamics, from the design fire to the moment a detector or sprinkler responds, each tied to the NFPA standard that publishes it.

  • Each tool follows a published NFPA standard or code
  • Free, runs in your browser; your inputs stay on your device
  • Screening tool, not reviewed or sealed by a licensed engineer
  • Last updated October 2026

The Calculators

NFPA 72 / NFPA 92t-Squared Fire Growth CalculatorDesign fire curves with a peak cap, sprinkler control or full burnout from the fire load, plotted and downloadable as CSV.Open calculator NFPA 72 Annex BCeiling Jet Temperature and Velocity CalculatorGas temperature and velocity under the ceiling at a sprinkler or detector, by the Alpert correlations.Open calculator NFPA 555Compartment Fire Temperature CalculatorUpper layer temperature in a room fire: door open (MQH), forced ventilation or closed room.Open calculator NFPA 72 Annex BHeat Detector and Sprinkler Activation Time CalculatorWhen a heat detector or sprinkler operates in a growing or steady fire, from its RTI, rating and spacing.Open calculator NIST FDS User’s GuideFDS Mesh Size CalculatorD*, cell size for coarse, moderate and fine D*/dx, and FDS-friendly IJK cell counts for a domain.Open calculator NFPA 92 / NFPA 72 Annex BFire Plume Temperature and Velocity CalculatorCenterline temperature, gas velocity and plume width at a height above the fire, with a profile chart.Open calculator NFPA 92Flame Height CalculatorMean flame height from heat release rate and fire area, with the NFPA 92 limiting elevation and a scale sketch.Open calculator NFPA 555Flashover CalculatorHeat release rate for flashover by the MQH, Babrauskas and Thomas methods.Open calculator NUREG-1805Time to Ignition CalculatorPiloted ignition time of thick and thin solids, critical heat flux and the flux needed for ignition.Open calculator NUREG-1805View Factor CalculatorConfiguration factors for rectangles and flame cylinders, with superposition and incident heat flux.Open calculator

About Fire Dynamics and Detection Calculators

Performance-based design, detector spacing and smoke control all start from the same correlations: how fast the fire grows, how tall the flame is, how hot the plume and the ceiling jet get, and when a heat-sensing element reaches its rating. These calculators implement those correlations with the validity limits that come with them.

Each tool cites the NFPA standard that carries the method, such as NFPA 72 Annex B, NFPA 92 or NFPA 555, and the original paper behind the correlation.

Other categories

Engineering aid only, provided as is and without warranty. Results depend on the inputs and on the simplifying assumptions of the method summarized on each tool page, and DGA has not verified them for your application. They do not replace code-required design, testing or review by the licensed engineer responsible for the project. Use of the tools is subject to the Terms of Use.

Quick inquiry

Need these results reviewed for a submittal?

Your name, a way to reach you, and where the project is. One of our licensed PEs replies within one business day. Every inquiry is confidential.

Prefer to describe it first? Open the Project Desk